Insert the WATER PRESSURE CONTROL TUBE into the center of the
Fill the WATER BARREL with safe, uncontaminated water (preferably
non-chlorinated water) to approximately one inch from the brim of barrel.
Place the SPROUT BARREL onto the WATER BARREL.
Insert the assembled WATER TUBE into the sprout barrel.It is
important to align the connecting tubes carefully. If the tubes are not
connected and aligned correctly, water pressure will be lost.
Place the LOWER TRAY (w/larger tabs up) into the SPROUT BARREL
and sprinkle seeds evenly. Cover with the UPPER TRAY
(w/larger tabs up).
Place the SPRINKLER on top of the WATER TUBE and cover
it with the TOP LID.
Plug the FreshLife Sprouter's cord into the appropriate outlet.
When your sprouts have grown to the desired height(varies with
the type of seed used) they are ready to harvest.
To harvest your sprouts, remove sprouts from the SPROUT BARREL. The
roots will be attached to the SEED TRAY; you can pull them from the tray
or cut them. Place sprouts in a bowl of clean water and agitate to
separate the clumps of sprouts. After removing the sprouts from
water, drain and place them in a storage container. Store it in
the refrigerator to maintain freshness. Most sprouts will remain fresh
for 4-7 days when refrigerated, but make sure you check for
the freshness before consumption.
Freshlife Cleaning Instruction.
a. Unplug the unit from the electric outlet
b. Disassemble the unit.
c. Wash the LID, SPLINKLER, SEED TRAYS, WATER TUBE,
PRESSURE CONTROL TUBE and SPROUT BARREL throughly with
cold or lukewarm water.
d. The WATER BARREL and the MOTOR CHAMBER are attached
together. Do not emerge the WATER BARREL into the water
when cleaning. Clean the inside of the WATER BARREL with water and
wipe the outside of the WATER BARREL with a clean towel.